Fronteq FS0507T, Руководство по эксплуатации и обслуживанию

Страница: 11 / 48

FS0507T PN 60711000162
●
When the machine is walking, in order to prevent the machine from rolling over,
please lower the machine platform to the bottom of the operation.
●
When the working platform slides in the extended state of the table, when walking
with the direction is changed, the extension of the table will occur more than expected,
and there is a risk of accidents due to collision with surrounding equipment or houses.
●
When starting the machine, please walk at low speed and adjust the walking speed
according to the road surface condition. Do not start urgently, stop suddenly, or make
sharp turns. Do not start urgently, stop suddenly, or make sharp turns.
Warning
Attention when walking on a sloping ground
●
When the machine is walking, in order to prevent the machine from rolling over,
please lower the machine platform to the bottom of one person operation.
●
When walking on an inclined floor, in order to prevent rollover, do not extend the
extension platform and walk in the forward direction.
● When walking on a sloping ground (downhill), make sure that the parking brake is
valid and must travel at a low speed.
● Do not carry cargo when walking on an inclined floor. It may cause the goods to
move,or may lose balance and cause unexpected accidents.
● The unit may be tilted sharply when entering the inclined floor. When driving into a
sloping ground, please walk at a low speed.
●
Be sure to use a wheel stop when parking on a sloping road.
● Do not enter the inclined floor when the operating platform is raised. When the
operating platform is raised, it is no longer possible to walk on tilt ground and the
machine will stop automatically.
● When crossing the steps, please set the slope. Please control the angle of the slope
below 7 degrees.
● When the inclined road surface is V-grooved or concave-convex, the crawler will float
and there is a danger of halving the brake effect. Please do not walk.
● If you go straight downhill from the uphill slope, the unit may be tilted sharply. Please
drive into the flat ground first, and bring the fuselage to a stable speed and then enter
the slope at low speed. In this case, make sure that the length of the flat ground
exceeds the total length of the unit (1390m).
●
When walking on a slope of more than 7 degrees, remove the upper operation panel
and connect it to the machine through the control line to remotely control the unit.
Warning
Attention when lifting
●
Before lifting the machine, check if there are any obstacles on the top of the head
and make sure that the machine can stop in time.
● In order to prevent the ceiling from coming up during the ascent operation, stop the
rise early.
●
When the machine operating platform rises, it is absolutely not allowed to enter the
bottom of the operating platform. Also, do not place objects under the scissor bar.