Fronius Virtual Welding, Руководство по эксплуатации

Страница: 55 / 168

55
EN
The "Info" buttons provide information about the available tasks. The tasks can be activat-
ed and deactivated whenever required. This allows you to create an individually tailored
training course. The threshold indicates the performance level (accuracy) in % below which
the colour of the display elements explained below changes from green to yellow.
For example, if 75% is set, the display element will remain green when an accuracy level
of between 100% and 75% is achieved. From 75% to 50%, the colour changes to yellow.
From 50% and below, the display element turns red.
The green area can only be set within a range of 60% to 90%.
MIG/MAG tasks The following tasks are available for the metal active gas welding process:
The colour of this ball (GHOST) shows how accurately the welding torch is being guided.
-
Green: very good
- Yellow: within the tolerance
- Red: outside the tolerance - requires correction!
Speed
The trainee practises guiding the welding torch at the correct speed and in the correct po-
sition. Proceed as follows:
Bring the tip of the torch to the target point until it turns green, indicating that the po-
sition is correct.
Guide the welding torch so that the ball on the torch tip is always in the centre of the
target point.
1
2
Speed / Stick out
In addition to the welding speed, the trainee also practises guiding the welding torch to
the workpiece with the correct stick out.
The colour of the distance arrow (GHOST) shows how accurately the welding torch is be-
ing guided.
-
Green: very good
- Yellow: within the tolerance
- Red: outside the tolerance - requires correction!