Fronius TransTig 1700, Руководство по эксплуатации

Страница: 93 / 124

Nothing happens when the torch trigger is pressed
Mains switch is on, indicators are lit up
The control plug is not plugged in
Plug in the control plug
Welding torch or welding torch control line is faulty
Replace welding torch
Cause:
Remedy:
Cause:
Remedy:
No protective gas shield
All other functions are OK
Gas cylinder is empty
Change the gas cylinder
Gas pressure regulator is faulty
Change the gas pressure regulator
Gas hose is not fitted or is damaged
Fit or change the gas hose
Welding torch is faulty
Change the welding torch
Gas solenoid valve is faulty
Contact After-Sales Service
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Poor weld properties
Incorrect welding parameters
Check the settings
Grounding (earthing) connection is incorrect
Check the grounding (earthing) connection and terminal for correct
polarity
Cause:
Remedy:
Cause:
Remedy:
The welding torch becomes very hot
The dimensions of the welding torch are inadequate
Observe the duty cycle and loading limits
Only on water-cooled machines: water flow is insufficient
Check the water level, water flow rate, cleanliness, etc. If the coolant
pump is blocked: use a screwdriver - placed on the bushing - to turn
the coolant pump shaft
Only on water-cooled machines: C-C parameter is set to "OFF".
In the set-up menu, set the C-C parameter to "Aut" or "ON".
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
93
EN