Fronius DeltaSpot, Инструкция по эксплуатации/Перечень запасных частей

Страница: 57 / 84

55
EN
DeltaSpot resistance spot welding
General The most significant feature in the case of DeltaSpot resistance spot welding is the process
tape. As well as protecting the electrodes, it offers additional advantages such as the con-
trol of the heat input, improvement of efficiency and the ability to bond very different mate-
rials.
Process tape con-
sumption If the process tape is advanced 10 mm after each spot weld, a 70 m tape can produce a
series of approximately 7000 spot welds.
Welding gun ad-
justment Adjusting the welding gun enables the spot welding gun to be adjusted to fit the workpiece
and to compensate for part tolerances.
Welding gun adjustment activated
If welding gun adjustment is activated, both gun arms are able to move freely around their
axis. During welding, both gun arms close simultaneously. In this case, one of the gun arms
usually makes contact with the component first and stops the closing process. The second
gun arm continues to close until it also comes into contact with the component. After build-
ing up the preset force, the welding process begins.
X-gun:
during the welding process only
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
-
these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! Machines that start up automatically can cause serious injury and
damage. In addition to these operating instructions, the safety rules issued by the
manufacturer of the robot and welding systems must also be observed. For your
personal safety, ensure that all protective measures have been taken and will re-
main in place for the duration of your stay within the working area of the robot.
2
1