Fronius ActiveCharger 1000, Руководство по эксплуатации

Страница: 21 / 72

21
EN
Any safety devices and parts that are not functioning properly or are in imperfect condition
must be repaired by a qualified technician before switching on the charger.
Never bypass or disable protection devices.
After installation, an accessible mains plug is required.
EMC measures In certain cases, even though a device complies with the standard limit values for emis -
sions, it may affect the application area for which it was designed (e.g. when there is sen -
sitive equipment at the same location, or if the site where the device is installed is close to
either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate action to rectify
the situation.
Maintenance Before switching on, always check the mains plug and cable as well as charger leads and
charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and solvent-free cleaning
agent only.
Repair Repair work must only be carried out by authorised personnel. Use only original replace -
ment and wearing parts (also applies to standard parts). It is impossible to guarantee that
bought-in parts are designed and manufactured to meet the demands made on them, or
that they satisfy safety requirements.
Do not carry out any modifications, alterations, etc. to the device without the manufactur -
er's consent.
Warranty and lia -
bility
The warranty period for the charger is 2 years from the date of invoice.
However, the manufacturer will not accept any liability if the damage was caused by one
or more of the following:
- Use of the charger "not in accordance with the intended purpose"
- Improper installation and operation.
- Operating the charger with faulty protection devices.
- Non-compliance with the operating instructions.
- Unauthorised modifications to the charger.
- Catastrophes caused by the activities of third parties and force majeure.
Safety inspection The manufacturer recommends that a safety inspection of the device is performed at least
once every 12 months.
A safety inspection should be carried out by a qualified electrician
- after any changes are made,
- after any additional parts are installed, or after any conversions,
- after repair, care and maintenance has been carried out,
- at least every 12 months.
For safety inspections, follow the appropriate national and international standards and di -
rectives.