7
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread
Tape
or Sealant
Two hose adapters
1½” x 1½” x 1¼”
Two Sections of 1½”
or 1¼” Flex Hose
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eye ball fittings in the return
jets to a smaller or larger size to
adjust back pressure. For best
results use King Technology’s
pressure gauge, order part number
01-22-4000.
Base Flex-Hose Installation
The POOL FROG Twin Cyclers should
always be installed between the filter
and pool (or between heater and pool if
applicable).
Never install POOL FROG Twin
Cyclers before the heater or damage to
the heater could occur.
Apply pipe thread tape or
sealant to the threaded end
of both hose adapters.
Screw adapters into each end of the POOL FROG Twin
Cyclers. Hand tighten. Finish tightening by turning 1 to 2
revolutions with a pipe wrench.
DO NOT OVER TIGHTEN.
Attach the filter section of flex hose to one
hose adapter and the return section of flex
hose to the other hose adapter with clamps
and tighten with screwdriver. Bi-flow valve
design allows water flow in either direction.
To prevent damage to
heaters or filters, see your
dealer about installing a
corrosion resistant check
valve
which will reduce the
back flow of chlorine gas
when the Cyclers are turned
off.
1.
2.
3.
4.
5.
FILTER
HOSE CLAMP
FILTER &
PUMP
HOSE
CLAMP
1 1/2” X 1 1/2” X 1 1/4”
HOSE ADAPTER
1 1/2” OR 1 1/4”
FLEX HOSE
HOSE
ADAPTER
HOSE
CLAMP
CHECK
VALVE
HOSE
ADAPTER
TO POOL
For better stability, POOL FROG
Twin Cyclers may be mounted on
a treated wood base using
Phillips
pan head screws,
one in front
and one in back of each Cycler. If
you have questions about stability,
please contact your dealer or King
Technology.
Install
