6
Installation Tips to Ensure Proper Performance
A. With High Flow Rate
(greater than 80 gpm)
Install T-fittings exactly as shown.
C. Pool and Spillover Spa Combination
POOL FROG
TWIN CYCLERS
POOL FROG
TWIN CYCLERS
B. With In-Floor Cleaner - TWO OPTIONS
✙
✙
✙
✙
✙
Flow
Flow
The best option is to have two lines.
One line with pump, filter, heater and
POOL FROG Twin and a second line with a separate pump for the in-floor
cleaning system (filter optional).
OPTION 1- A Two-Line Installation
OPTION 2 - A 3-Way Valve Installation
POOL WATER LEVEL
POOL RETURN
3-way manual valve or 3-way motor valve plus controls
POOL FROG
TWIN CYCLERS
POOL FROG
TWIN CYCLERS
IN-FLOOR
CLEANER
VALVE
IN-FLOOR
CLEANER
VALVE
FILTER
FILTER
FILTER
HEATER
PUMP
PUMP
PUMP
Line 1
Line 2
1) If using a multi-speed pump, run
pump for at least 6 hours per day
at high speed (at least 40 gpm).
If the pump will run on low speed 24
hours per day or less than 6 hours per
day on high speed, you must bleed the
air while the pump is on by unscrewing
both Cycler back knobs until water
appears from both Cyclers. Then screw
the knob back in. Repeat this process
each time the cap is removed for any reason.
2) Install system with 4-8 psi back pressure.
Lower back pressures could result in under
chlorination. Change the eyeball fittings in
the return jets to a smaller size to increase
back pressure. Contact King Technology at
800-222-0169 for a specially designed Cycler
pressure gauge to determine back pressure
at pool start-up.
3) Special installation Requirements:
•
If water flow is higher than 80 gallons per minute (gpm),
see diagram A.
•
If an in-floor cleaner is included with pool,
see diagram B, with two options. Preferred
installation is Option 1 with two separate lines.
•
If set-up is a pool and spa combination with
common equipment, see diagram C.
Questions?
Call Customer Service at 800-222-0169
Monday thru Friday, 8 am to 5 pm central standard time.
IMPORTANT:
Over chlorination or damage to the
POOL FROG Twin Cyclers or other equipment could
result if special installations A, B or C are not used in
these situations.
WARNING
• Do not exceed maximum operating pressure of 50 psi.
• Do not install automatic or fast shut off valves
downstream of feeder.
• Always install the POOL FROG Twin Cyclers AFTER
the heater (if applicable) on the return line.
• Always install any additional sanitizing equipment
AFTER and NEVER BEFORE the POOL FROG Twin
Cyclers are installed on the return line.
Before installing, read all directions carefully and contact your dealer for installation support.
