Fritsch 16.60 0 Series, Руководство по эксплуатации

Страница: 24 / 42

6.2.2 Closing the device
The grinding chamber can only be locked when the
device is connected to the mains and the main switch
on the rear of the device has been switched on.
1. Close the door.
2. Pull the door lock (7) upwards.
3. The locking mechanism (8) clicks into place.
Only after the Start button has been pressed does the door lock
electrically.
6.3 Installing the grinding elements
NOTICE!
The steps must be gone through in the sequence set
out below. Before assembly it is essential to ensure that
both the motor shaft and the mounting bore hole of
the cross beater have been cleaned.
6.3.1 Einsetzen der Mahlraumkassette
n
Pull the knob (10) upwards.
n
Align the grinding chamber cartridge (2) with the bolts in the
housing.
n
Insert the grinding chamber cartridge (2) into the housing and allow
the bolt of the knob (10) to click into the perforation in the grinding
chamber cartridge.
6.3.2 Inserting the bottom sieve
n Slide the sieve frame (2.1) into the grinding chamber cartridge (2).
Using the device
- 24 -