Frigidaire MFM-6D, Руководство по обслуживанию

Страница: 31 / 58

30
(1) Remove the gasket door (A06) from door plate.
(2) Remove the barrier screen inner (A05) from door plate.
(3) Remove the door frame (A02) from door plate.
(4) Remove the top hinge stopper (A03) from door plate.
(5) Remove the spring (A08) and the hook (A07).
(6) Remove the barrier screen outer (A01) from door frame (A02).
(7) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door
seal and the oven front surface.
(1) To reduce gap located on part 'A'.
1) Remove the cabinet.
2) Loosen two screws on the top hinge
stopper, then push the door to contact the
door seal to oven front surface.
3) Tighten two screws.
(2) To reduce gap located on part 'B'.
1) Loosen three screws on under hinge stopper, then push the door to contact the door seal to
oven front surface.
2) Tighten three screws.
(3) To reduce gap located on part 'C'. (See Fig. 5)
1) Remove the cabinet.
2) Loosen a screw on interlock switch assembly located top of oven body.
3) Draw the interlock switch assembly inward as possible to engage with hook on the door
bottom.
4) Tighten a screw.
(4) To reduce gap located on part 'D' (See Fig. 6)
1) Remove the cabinet.
2) Loosen a screw on interlock switch assembly located bottom of oven body.
3) and (4) are same as step (3).
A C
B D
Hook
Mounting screw
Secondary
interlock
switch
Hook
Mounting screw
Primary
interlock
switch
NOTE: A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm 2
Fig. 5 Fig. 6