22
Door Seal
1. Door seal just pulls out of channel around tub.
2. To replace find center of gasket make sure back
goes into channel first. Back is marked with a
color stripe.
4. Go to bottom on either side find block molded
into bottom of tub fill block with gasket.
5. Form gasket into an
“L” press gasket up
channel in several
spots. See Figures
37&38
6. Repeat steps 4 and 5 for opposite side
7. Close door to seat seal.
Bottom Door Seal
1. Remove lower rack from tub
2. Open door completely down door seal can be
pulled out from the right side. See Figure 39 &
40
3. Pull straight into tub.
4. When installing new seal place seal in channel
just enough to hold in place
5. Close door for tub to push seal in place.
3. Starting at center
top press gasket
into channel just to
hold in place See
Figure 36
Upper Rack
There are two tub roller assembly, front and rear, on
both sides of the tub. Each assembly has a top
and a bottom rollers installed on a mounting plate
with molded in axles, these assemblies are
screwed into the tub using two screws. See Figure
41.
1.
To remove rack, unsnap and remove retainers at
end of metal track. Once retainers are removed,
pull rack straight out.
Tub Roller Assembly
Front Assembly
Rear Assembly
CENTER SPRAY ARM
1. Pull upper rack forward to gain access to spray
arm.
2. Center spray arm and delivery tube are an
assembly, push this assembly to the rear to
loosen and remove from rack. See Figure 42
Retaining clip
Push
Upper Spray Arm
To remove the upper spray arm turn the mounting
nut counter clockwise to unscrew from delivery tube.
If mounting nut is too tight place the handle end of
pliers into the notches and turn to remove.
Figure 36
Figure 37
Figure 38
Figure 39
Figure 40
Figure 41
Figure 42
Bottom
Center cut out
