21
Door Latch
1. Disconnect the dishwasher from electrical supply
2. Remove outer door panel
3. Remove console
4. Remove wires from both door switches
5. Remove two Torx screw holding latch See Figure 33
6. Pull latch out at the top from inner door panel and up
to clear location tab on rear of latch. See Figure 32
7. On installing wires on door switches make sure both
white wires are on one switch and both black wires
are on the opposite switch.
8. Install latch in reverse order.
Door Strike
The door strike mounts to the top frame of tub with two
5/16 bolts the strike is not adjustable. The strike is the
part the door latch attaches to when closed. To replace
the tub will have to be pulled forward to access the two
mounting bolts. See Figure 34
Detergent/ Rinse aid Dispenser
1. Disconnect the dishwasher from electrical
supply
2. Remove outer door panel
3. Disconnect wiring from dispenser
4. Remove six Phillips screws and carefully
push dispenser into the tub
To diagnose operation of the dispenser use the
Water Service Test
See the section on testing the control system.
Door hinge
1. Disconnect the dishwasher from electrical
supply
2. Remove outer door panel
3. Dishwasher needs to be pulled forward to
replace door hinge
4. Check water line and drain hose before
removing counter top screws and pull
forward.
5. Remove cable and spring from hinge.
6. Remove bolts mounting hinge to inner door
panel. Take care not to damage foam baffle
at bottom of inner door panel.
7. Remove hinge pin hold hinge support with
pliers while removing pin.
8. Install hinge make sure the shoulder on
hinge pin is properly in hole in hinge before
tighten pin.
9. Complete repair in reverse order.
Wax motor
Reed switch connections
Linkage to rinse aid dispenser
Pivot for detergent door latch
Figure 32
Figure 33
Figure 34
Figure 35
Location pins
Lock tab
Mounting Screws
