Frigidaire FNGB90JFUW, Руководство пользователя

Страница: 32 / 40

Flexible nonmetal pipes
connection
If you have an easy access to the
connection, you can use a flexible pipe.
The flexible pipe must be tightly attached
by clamps.
In installation always use the pipe holder
and the gasket. The flexible pipe can be
applied when:
• it can not get hotter than room
temperature, higher than 30 °C,
• it is not longer than 1500 mm,
• it has no narrowing anywhere,
• it is not twisted or tighten,
• it does not get in touch with sharp edges
or corners,
• it's conditions can be easily checked.
When checking the flexible pipe make sure:
• it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length,
• the material is not hardened, but shows
its correct elasticity,
• the fastening clamps are not rusted,
• expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
WARNING!
When installation is complete, make
sure that the seal of each pipe fitting
does not leak. To check the seal use a
soap solution, not a flame.
The gas supply ramp is on the rear side of
the control panel.
WARNING!
Before you connect the gas,
disconnect the appliance from the
electricity supply or switch off the fuse
in the fuse box. Close the primary
valve of the gas supply.
Adjustment to different types
of gas
WARNING!
Let only an authorized person do the
adjustment to different types of gas.
If the appliance is set for natural gas
you can change it to liquid gas, with
the correct injectors.
The gas rate is adjusted to suit.
WARNING!
Before you replace the injectors, make
sure that the gas knobs are in the Off
position. Disconnect the appliance
from the electrical supply. Let the
appliance cool down. There is a risk of
injury.
The appliance is set to default gas. To
change the setting choose a pipe
holder from the list. Always use the
gasket sealing.
32
INSTALLATION