17
STEP 4.
Place unit in window with the bottom support rail up against the
back edge of the window sill. Center and close window sash
onto upper support rail. The unit should be level or slightly
tilted outside (1/4" tilt). (See Figure 15) NOTE: Depending
on the type of window, install the appropriate security lock as
recommended by manufacturer.
CAUTION
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit
Failure to do so can result in minor
to moderate personal injury.
STEP 5.
Extend side curtains to fill window. Secure outer top corner
of both curtain (left and right) to window jamb and window
sash using supplied screws. 1/2" screws (Item E in parts list)
and 1 1/4" screws ( Item F: in parts list) have been provided to
accommodate varying window types. (See Figure 16)
If you desire a more permanent installation, you can secure your curtains
using both screw holes and your unit sleeve directly to the lower window
stool using the instruction Steps 5.1 - 5.3 shown below. If you choose the
standard installation already covered in Steps 1 - 5, then you can proceed
to Step 6 found on Page 18.
Pull unit from sleeve, using the side handles located on
either side of the decorative front. Obtain assistance as
needed. Place unit out of the way on a secure, flat surface.
(See Figure 17)
STEP 5.1.
NOTE: WHEN REMOVING UNIT FROM SLEEVE AND CARRYING OR
HANDLING UNIT, OBTAIN ASSISTANCE OR HELP AS NECESSARY
TO SUPPORT UNIT FROM BOTTOM (BASEPAN), MAINTAINING
CLEARANCE FROM ALL OBSTACLES. (See image below)
Figure 15
Figure 16
Figure 17
SECURE TO WINDOW
SASH THROUGH TOP
SCREW HOLE
THIS STEP MUST BE FOLLOWED COMPLETELY TO INSURE
UNIT IS ADEQUATELY SECURED TO WINDOW.
SECURE TO
WINDOW JAMB
THROUGH
BOTTOM / SIDE
SCREW HOLE
