FRIATEC FRIAMAT BASIC ECO, Руководство по эксплуатации

Страница: 7 / 44

7
display very different control characteristics, the
suitability of a generator cannot be guaranteed by
the specified rated output alone.
When in doubt (e.g. when purchasing brand new)
contact an authorised service station or call the
FRIATEC service h49 (0) 621 486 1533.
Only use generators working with frequencies within
the 44-66 Hz range.
Start up the generator and leave it running for half a
minute. If necessary adjust off-load voltage and limit
to voltage indicated by the technical data. Genera-
tor (power) safety fuse at least 16 A (slow acting).
WARNING!
Check input voltage of your FRIAMAT
®
-model
before starting the fusion process. Your
FRIAMAT
® -model has been designed for input
voltage of 190-250 volt.
When using an extension cable, please ensure
sufficient cross section:
- 2.5 mm 2 up to 50 m
- 4 mm 2 up to 100 m length.
Always roll out cable fully before use! Do not con-
nect any other equipment to the same generator
while fusion is taking place! At the end of the fusion
process, first disconnect the power cable from the
generator and then shut off the generator.
DANGER!
Danger to life! Never open your FRIAMAT ® -model
whilst connected to power supply! FRIAMAT ®
fusion units may be opened only by specialist
personnel at an authorised service station! Re-
placement of damaged mains connection must
be carried out by authorised service station only.
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 7