FRIATEC FRIAMAT BASIC ECO, Руководство по эксплуатации

Страница: 35 / 44

35
7. Operating faults
7.1 Errors when reading in the barcode
If reading in is not confirmed by an acoustic signal
the reader wand should be checked for dirt or
damage. If the reader wand is damaged, fusion can
still be carried out using the Emergency Input Mode.
7.2 Overheating
It is possible for your FRIAMAT ® -model to overheat if
used for extreme lengths of time. In order to avoid
damage to the unit, a temperature monitor has been
installed which causes your FRIAMAT
® -model to
calculate before fusion whether the temperature
increase to be expected during fusion is permitted.
If the calculated temperature is not in the permitted
range, the display will show the message “Let the
unit cool down”.
As the power consumption of different electrofusion
fittings will vary, there may be the option of fusing a
different fitting.
7.3 Fusion interruption
If the fusion is interrupted, because e.g. the power
supply was disrupted during a fusion process, the
fusion can be repeated once the source of the fault
has been removed and the fitting has cooled down
completely (depending on manufacturer, please
observe operating instructions by the appropriate
fitting manufacturer).
7.4 Error messages/Warning messages/
Info
If irregularities occur during the fusion process, your
FRIAMAT
® -model will display the appropriate error
messages.
IMPORTANT!
In the event that your FRIAMAT ® -model displays
an error message or warning message not
described below and this cannot be clarified or
rectified based on the description in the display,
please contact our service h49 (0) 621 486
1533.
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 35