Fri-Jado STW5, Руководство по установке

Страница: 7 / 22

Page 7 Installation Manual STG5/7 STW5/7 form 9123656 rev. 03/2010
INSTALLATION PROCEDURES
Each oven and warmer is furnished on 40mm legs. Stacked models are furnished with 2 swi-
vel and 2 locking swivel castors. A castor-equipped stand with convenient storage drawer is
available; the oven is mounted on top of the stand.
LEGS / cASTORS
TEThERING Of ThE UNIT
(For model STG 5 and STG 7 units when stacked or placed on base with castors)
Warning: Safety standards require that, when this appliance is properly connected to the
electrical power supply using flexible conduit, adequate means be provided to limit move-
ment of the appliance without depending on or transmitting stress to the electrical conduit.
This means that, as part of the installation, the base or bottom unit of stacked models must
be secured to the building structure (typically either wall or floor) to limit the movement of
the appliance and, thus, helping to prevent damage to the conduit during cleaning, main-
tenance and service operations.
A tether bracket, as shown on the drawing below, is provided with the base or stacking kit.
Based on the routing of the flexible conduit, the bracket must be installed along with the
caster to one corner of the base using the hardware provided. The remaining open hole in
the center of the tether bracket is to be used to secure one end of the tether (locally supplied
chain, cable, etc.). The other end of the tether is to be secured to an anchoring point in the
building structure.
Note: Length of tether must be shorter than the flexible conduit to make sure that during
appliance movement, no stress is transmitted to the conduit.
Warning: Following installation, check to confirm that, when the appliance is moved to the
limits of the tether in each direction, no stress is transmitted to the electrical conduit.