Fri-Jado STW5, Руководство по установке

Страница: 6 / 22

1 2 3 4 5 6
N L1
1 2 3 4 5 6
L2 L1 L3 N
1 2 3 4 5 6
L2 L1 L3
Page 6 Installation Manual STG5/7 STW5/7 form 9123656 rev. 03/2010
INSTALLATION PROCEDURES
Prior to installation, test the electrical service to assure that it agrees with the specifications
on the
machine data plate located on the right side panel near the controls. The connecting cable
for the unit must be equipped with an approved plug connection. If use is to be made of a
permanent connection, the connecting cable must be connected to a manual on/off switch
that is installed near the unit in a clear visible manner.
ELEcTRIcAL SUPPLy
IMPORTANT: Make sure you lea-
ve sufficient space around the
rotisserie or warmer to easily
remove or insert the rotor. If the
base has (rotating) wheels, the
floor on which it rests must be
level.
LOcATION
The oven must be installed on a level surface. The installation location must allow adequate
clearances for servicing and proper operation.
The connecting cable for the unit must be equipped with an approved plug connection. If
use is to be made of a permanent connection, the connecting cable must be connected to a
manual on/off switch that is installed near the unit in a clear visible manner.
For a single-phase 200 V or 230 V ~ circuit with
neutral, the unit must be connected according to
the figure below. For a 3-phase 400 V ~ circuit with neutral, the
unit must be connected according to the figure
below. For a 3-phase 200 V or 230 V ~ circuit without
neutral, the unit must be connected according to
the figure below.
400 V, 3N ~ 50...60 Hz 200 V or 230 V, 1N ~ 50...60 Hz 200 V or 230 V, 3 ~ 50...60 Hz