Fresenius Kabi OPTIMA PT-VS-S, Техническое руководство

Страница: 97 / 106

optima07.1_001b_en.fm 97
C
a
libr
at
io
n
!
EtAL.9
, press "START".
Resetting the pressure calibrations
" Choose "YES" or "NO" using the selection keys and
confirm.
" If "YES", the calibration values for the pressure sensors
are reset to zero, for all tubes.
" If "NO", the calibration values are reset to zero only for the
tube selected.
If the calibration of the pressure sensors should be performed only for the tube selected,
it’s recommennded to choose "NO".
When choosing "YES" a calibration for all the tubes programmed should be carried out
using VP control maintenance sofware.
When changing the force sensors, the calibration should be done for all the tube available
on the pump.
The calibration described below is concerns only the active tube chosen through mode
key / set selection or maintenance / SAV 2.
" Press "CONFIRM" key to start the calibration.
Calibrating the downstream and upstream pressure sensor with the door open.
"
PaV.1
,
PaM.1
: open the door of the Optima
pump, no tube installed.
" Press "ENTER".
#
The values for "downstream pressure sensor door
open" and "upstream pressure sensor door open" are
read and recorded.
#
The threshold for "downstream pressure door open"
must be between 1997 < X < 4453 mV.
#
The threshold for "upstream pressure door open"
must be between 1197 < X < 4297 mV.