Baggage Compartment Lights
Baggage compartment lights are located on the un-
derside of the lower bunk, on both sides. Both lights
turn on when either baggage compartment door is
opened to illuminate the baggage compartment. The
lights also come on when the lower bunk is raised.
Cab Overhead Console Lights
The overhead console includes a clear reading light,
a clear dome light, and a red map light. The dome
lights illuminate when a door opens, then stay on for
a short time after both doors are closed. Press the
lens of the reading light, dome light, or map light to
activate each one.
Foot Well Lights
When the driver or passenger doors are opened, red
lights illuminate both foot wells. These lights can also
be activated with the foot well light switch. See
Fig. 2.26
. Press the upper half of the switch to turn
the foot well lights on, press the lower half of the
switch to turn them off.
The sleeper foot well switch is located in the lower
switch module in the sleeper. It looks identical to the
cab foot well switch. See
Fig. 2.26
. When the switch
is activated, two lights illuminate the sleeper floor.
Instrument Panel Lights
The instrument panel lights illuminate when the
headlights are turned on. When the headlights are
on, the panel lamp switch controls the intensity of the
instrument panel lamps. Slide the switch up to
brighten them and down to dim them. When the
headlights are turned on, the panel lights setting will
default to the intensity that was last set.
Rear-Wall Dome Light
A rear-wall dome light is available on all sleeper
cabs. It is located on the rear wall where the wall
meets the roof. To turn on the rear-wall fluorescent
light, press the dome light switch on either the lower
or upper bunk control panels.
Sleeper Dome Light
A sleeper dome light is located on the roof, between
the bunk and the cab on sleeper vehicles. The rear
cab dome light will activate with the dome lights
when a door is opened, then stay on for a short time
after both doors are closed. Use the dash-mounted
switch or the switch in the sleeper panel to activate
the rear cab dome light. See
Fig. 2.26
.
Sleeper Reading Lights
Clear reading lights are mounted above the lower
bunk in the rear corners of the sleeper. There are
two switches in the sleeper control panel for the
reading lights. To turn a reading light on, press the
upper half of the switch. Press the lower half of the
switch to turn it off.
The reading lights can also be activated by pressing
the lens.
PTO Switch
To activate the PTO function, press the upper half of
the switch. Press the lower half of the switch to de-
activate the PTO function.
Steering Column Tilt/Telescope
Control
WARNING
Make sure that the steering column is locked be-
fore driving the vehicle. Never tilt the column
while driving the vehicle. Doing so could cause
loss of vehicle control, personal injury, and prop-
erty damage.
Adjust the seat to the desired ride position, then tilt
or telescope the steering column as needed.
To tilt the steering column, press down on the foot
pedal located on the steering column. Tilt the steer-
ing column up or down to the desired position. Re-
lease the foot pedal to lock the steering column in
place.
To telescope the steering column, press down on the
foot pedal located on the steering column. Pull the
steering wheel closer to you or push the steering
wheel away from you. Release the foot pedal to lock
the steering column in place.
Instruments and Controls Identification
2.24
