freightliner 108SD, Руководство пользователя

Страница: 58 / 192

3. Tug on the seat belt to make sure it is securely
fastened. If the buckle unlatches, repeat this
step. If the problem continues, replace the three-
point seat belt.
4.
Snug the seat belt to your waist.
WARNING
Before activating the Komfort Latch or the Slid-
ing Komfort Latch, make sure the amount of
slack in the shoulder strap is set as described
below. Excess slack in the shoulder strap re-
duces the effectiveness of the seat belt, and in-
creases the risk of injury or death in an accident.
5. Position the shoulder strap diagonally across
your chest with the adjustable D-loop bracket (if
equipped). The shoulder strap must be centered
on your shoulder and chest, away from your face
and neck. See Fig. 6.10 . If desired, engage the
Komfort Latch or Sliding Komfort Latch as fol-
lows.
If equipped with a Sliding Komfort Latch, make
sure that the shoulder strap is snug against your
chest. Without loosening the shoulder strap,
push the Sliding Komfort Latch switch to the
"ON" position. See
Fig. 6.8 . To activate the latch
lean forward until you hear a click. This will allow
for approximately 1 inch (2.5 cm) of slack be-
tween your chest and the shoulder harness.
Once engaged, the latch will allow you to lean
forward about 5 inches (13 cm) without having to
reset the latch. Leaning forward more than 5
inches (13 cm) will disengage the Sliding Kom-
fort Latch, requiring it to be reset.
If equipped with a Komfort Latch, pull on the
shoulder strap to lessen the pressure of the strap
on your shoulder and chest. Allow no more than
1 inch (2.5 cm) of slack between your chest and
the shoulder harness. More slack can signifi-
cantly reduce the seat belt effectiveness in an
accident or a sudden stop. While holding the belt
slack, press the Komfort Latch lever up, clamp-
ing the seat belt webbing (
Fig. 6.11 and
Fig. 6.12 ).
6. Unbuckle the three-point seat belt and release
the Komfort Latch or the Sliding Komfort Latch
as follows.
If equipped with a Sliding Komfort Latch, un-
buckle the seat belt, then tug on the shoulder
belt to release the Sliding Komfort Latch,
or
press the Sliding Komfort latch to the "OFF" po-
sition, then unbuckle the seat belt.
07/02/2007 f910578
1
2
1. Latch 2. Buckle
Fig. 6.9, Three-Point Seat Belt Operation
08/09/2010 f910634
A B C
A. Correct—Belt is centered on your shoulder and
chest, away from your face and neck.
B. Wrong—Belt must not rub against face or neck.
C. Wrong—Belt must not hang off shoulder.
Fig. 6.10, Proper Shoulder Strap Fit
Seats and Restraints
6.8