FreeWave Technologies
HT Ethernet Addendum
900MHz
V1.0h
Menu 2,
The Call Book is to be set as normal for Point to Point configurations. Network ID (Menu 5,
option 6) is recommended for Point to Multipoint networks.
Menu 3 (for Point to Point)
RADIO PARAMETERS
(0) FreqKey
5
(1)
Max Packet Size
9
Recommended: "9" (for Asymmetric Data)
(2) Min Packet Size
1
Recommended: "1" (for Asymmetric Data)
(3) Xmit Rate
1
(4) RF Data Rate
2
Must be 2 if option B Delay (0-70) is invoked (set
to anything other than 0)
…
(A) High Noise
0
(B) Delay (0-70)
2
Used for range distance over 15 miles. All
Radios in network must have the same value.
(C) RemoteLED
0
(D) WideBand
0
Reserved for future use
.
(E) Encryption
0
Enables 256 bit encryption, configurable in
EZConfig only.
Menu 3 (for Point to Multipoint)
RADIO PARAMETERS
(0) FreqKey
5
(1) Max Packet Size
9
Recommended: "9" (for Asymmetric Data)
(2) Min Packet Size
1
Recommended: "1" (for Asymmetric Data)
(3) Xmit Rate
1
(4) RF Data Rate
3
Must use: “3” for Multipoint networks
…
(B) Delay (0-70)
0
Option not available in Multipoint Mode.
(C) RemoteLED
0
(D) WideBand
0
Reserved for future use
.
(E) Encryption
0
Enables 256 bit encryption, configurable in
EZConfig only.
Menu 5 (for Point to Multipoint)
MULTIPOINT PARAMETERS
(0) Number Repeaters
1
Set to "0"
(if none)
or "1"
(if any)
…
(A) Slave/Repeater
0
This function is not supported and therefore
should not be used with Ethernet radios.
* The new Option (B) Delay (0-70) has been created for the purpose of adjusting the timing of the
radios when used at distances of over 15 miles. The value will increment by 1 for each 1.07 miles
over 15 miles the longest link in the network accommodates. Throughput is reduced slightly for
each increment of the Delay value. The Data Rate setting must be set to a value of 2.
NOTE: The Delay Setting MUST be the same in ALL Radios in the network.
LAD0013AB Rev H
7 of 11
