1
FUSION SATELLITE
Quickstart Guide
©2022 FreeWave Technologies. All Rights Reserved. FreeWave Technologies and the stylized logo are trademarks of FreeWave
Technologies. All other trademarks are the property of their respective owners.
The antenna must be professionally installed on a fixed, mounted, and permanent outdoor structure to satisfy RF
exposure requirements.
Any antenna placed outdoors must be properly grounded.
Use extreme caution when installing antennas and follow all instructions included with the antenna.
UL and Safety Notification
FUSION-SAT a Listed component under UL File Number
5019876.
Standards and Editions
HazLoc Standards
UL 121201-2019
CSA C22.2 No. 213-17
Nonincendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Division 1 and 2 Hazardous
(Classified) Locations – Edition 3 Revision Date 2019/08/26
Ordinary Location Standards
UL 60950, 2nd Edition
CAN / CSA-C22.2 No. 60950, 2nd Edition
IEC 60950, 2nd Edition
EN 60950, 2nd Edition
Power Source
FUSION-SAT is intended to be operated from a Limited Power Source (LPS) or Class 2 power source in accordance
with IEC/EN/UL 60950-1 and CAN/CSA C22.2 No. 60950-1-07.
The FUSION-SAT is approved to operate with an input voltage range of +6 to +30 VDC, 4A, Tmra of 60°C.
Hazardous Locations Installation Instructions
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D OR non-hazardous locations only.
Open type device intended to be installed in a suitable enclosure that requires the use of a tool to access.
Ambient: -40°C to +85°C
Temperature Code: T5
Input voltage rating of +6 to +30 VDC, 4A
WARNING – EXPLOSION HAZARD. DO NOT CONNECT OR DISCONNECT WHEN ENERGIZED.
AVERTISSEMENT – RISQUE D’EXPLOSION. NE PAS BRANCHER NI DÉBRANCHER SOUS TENSION.
WARNING – EXTERNAL USE OF THE ANTENNA IS NOT PERMITTED. THE ANTENNA IS TO BE TERMINATED AND
MOUNTED INTERNAL TO THE FINAL INSTALLED ENCLOSURE
AVERTISSEMENT - L'UTILISATION EXTERNE DE L'ANTENNE N'EST PAS AUTORISÉE. L'ANTENNE DOIT ÊTRE TERMINÉE
ET MONTÉE À L'INTÉRIEUR DU BOÎTIER FINAL INSTALLÉ
The Antenna must be a 50OHM, passive type.
NOTICES
Accuracy
While reasonable efforts have been made to assure the accuracy of this document, FreeWave Technologies, Inc.
(“FreeWave”) assumes no liability resulting from any inaccuracies or omissions in this document, or from use of
the information obtained herein. Information in this document is provided solely to enable and support the use of
FreeWave’s products. There are no express or implied copyright licenses granted hereunder based on the
information in this document. FreeWave reserves the right to make changes to any products described herein to
improve reliability, function, or design, and reserves the right to revise this document and to make changes from
time to time in content hereof with no obligation to notify any person of revisions or changes.
FreeWave makes no warranty, representation, or guarantee regarding the suitability of its products for any
particular purpose, nor does FreeWave assume any liability arising out of the application or use of any product and
specifically disclaims any and all liability, including without limitation consequential or incidental
Содержание FUSION-SAT
Страница 1: ...FUSION SATELLITE Quickstart Guide...
