2201 Cantu Court Suite 215 Sarasota, FL 34232 Page 16 of 23
(941) 378-4242 (800-237-3928 Fax (941) 378-2765
Stewartsigns.com
7.
Locate the serial cable. This cable has a RJ45 connector on one end and a Panduit
connector on the other end. Connect the RJ45 connector to the Serial Port on the
Transceiver identified as “
COM 1”.
a.
On Traditional CPU boards, attach the Panduit connector to the RS232
port CPU labeled
“RS232”
This CPU board is located inside ID cabinet
ID#1. See figure #21.
b.
On New CPU boards connect the Panduit connector to RS232 port
board Marked “
UART RS232”
. This CPU board is located inside ID
cabinet ID#1. See figure #21a.
8.
On Traditional CPU Boards only. Make sure the RS232 / RS485 jumper is set
correctly. Locate jumper pin set marked
JP5,
(This jumper is located 1 inch above
and to the right of the connector you plugged the cable into in the previous step).
The jumper should be on the set of pins marked 232. See figure #21.
9.
Most New signs have the Antenna mount on the right side of the sign nine inches
below the top of the cabinet. Make sure all antenna connections are secure.
Figure #21 Traditional CPU Board inside the Sign
