P5F97/P5F103 User’s Manual
39
Video:
Set it to the type of graphics card installed in your system. If
you are using a VGA or higher resolution card, choose the “EGA/
VGA” option. The options are “EGA/VGA” (default), “MONO”,
“CGA 40" and “CGA 80".
Halt On:
The options are “All Errors” (default), “No Errors”, “All,
But Keyboard”, “All, But Diskette” and “All, But Disk/Key”. This
setting determines which type of errors will cause the system to halt
during bootup.
3.4 IDE HDD AUTO DETECTION
If your system has an IDE hard drive, you can use this utility to
detect its parameters and enter them into the Standard CMOS
Setup automatically.
If the auto-detected parameters displayed do not match the ones
that should be used for your hard drive, do not accept them. Press
the <N> key to reject the values and enter the correct ones manu-
ally on the Standard CMOS Setup screen.
Note: If you are setting up a new hard disk drive (nothing on it)
that supports LBA mode, more than one line will appear in the
parameter box, choose the line that lists LBA for an LBA drive.
Do not choose Large or Normal if the hard disk drive is already
fully formatted when you install it, choose the mode which is
used to format it.
Chapter 3: BIOS Configuration
