DEMO9S08QE8 User Manual
7
shows PTC1. Push button PTA2 and turn the potentiometer to
change these signals. This application may also be found at:
http://www.pemicro.com/fixedlinks/demoQEtoolkit.html.
Figure 3-1: DEMOQE Logic Analyzer Application
3.5
Hardware Setup
3.5.1
First-Time Connection
The DEMO9S08QE8 may be connected to a PC through a USB port.
Connection steps are listed below in typical order:
1. Install the required software, as described in the previous section.
2. Make sure the jumpers for USB_PWR, 3V for VOLT_EN, and
REG_VDD for VDD_SELECT are installed.
3. Plug the USB cable A-M connector into a free USB port of the PC.
4. Plug the USB cable B-M connector into the USB connector on the
DEMOQE Base Board.
5. The operating system will recognize P&E’s Embedded Multilink cir-
cuitry and P&E’s USB to Serial circuitry. Depending on the operating
system, you may see the “Found New Hardware Wizard” dialog, help-
ing you to install software for “PEMicro USB Multilink (i0). On Win-
dows XP (SP2), the following dialog will appear:
