Freescale Semiconductor MC13853 LNA, Руководство пользователя

Страница: 10 / 22

Initial Instructions
MC13853 LNA Evaluation Board User’s Guide, Rev. 1.3
1-4 Freescale Semiconductor
Figure 1-2. Serial Peripheral Interface Board (Top View)
1.3 Assembly Instructions
1. Interconnect the evaluation board, MMM6038SPI, PC computer, power supplies as shown in
Figure 1-1 .
2. Confirm on the MC13853 evaluation board that all DC voltages are present at the correct level
indicated in the MC13853 Data Sheet.
3. Verify on the MMM6038SPI at the red terminal that the voltage is +5 VDC.
4. An active green LED indicates DC “On” and an active green LED indicates that the FPGA has been
loaded successfully with the code from the flash memory.
5. The test equipment requirements and line-up are given in Chapter 3, “Basic Test Equipment
Setup ”, Figure 3-1 .
6. Install the supplied software from the CD-ROM in the chosen computer operating under Windows
NT or better (such as Windows 2000 or Windows XP). Minimum requirements for the PC
computer are: 40 MB of free hard drive space, 256 MB of RAM, CD-ROM drive, and a parallel
port I/O.
7. Connect the wire ribbon between the 8 pin header of the MC13853 evaluation board and the
MMM6038SPI board. On the MMM6038SPI board, the 8 pin connector goes on J9, the
VDDAuxSPI lead goes on TP2, the VCC lead goes on TP3 and ground (Gnd) goes on TP5.
Parallel Port
Interface
+5 VDC
(Red)
Voltage
Regulators
FPGA
3-Wire SPI
to LNA
Ground
Gnd
(Black)