8
•
Assembly requires two persons.
•
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
•
To identify small parts, see page 7.
•
Assembly requires the following tools:
one 3/8" hex key
one 7/32" hex key
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
ASSEMBLY
1. Place the Base Frame (56) onto two pieces of the wood
(A) found in the packaging of the incline trainer. Position
the wood on each side of the Base Frame behind the
feet as shown.
Place the Upright (93) near the front of the Base Frame
(56) as shown.
As you slide the Upright (93) onto the Base Frame (56),
insert the Frame Wire Harness (129) through the bracket
on the base and into the large hole on the front of the
Upright.
Be careful to avoid pinching the wire.
Align the holes in the Upright (93) with the holes in the
Base Frame (56).
93
56
A
1
Hole
129
2
2. Locate the Frame Wire Harness (129) and the Upright
Wire Harness (116) in the Upright (93) access hole.
Connect the Frame Wire Harness (129) and the Upright
Wire (116) at the front of the Upright (93).
See the inset
drawing.
The connectors should slide together eas-
ily and snap into place.
If they do not, turn one con-
nector and try again.
IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON THE
POWER.
129
116
93
129
116
