9
3
3. Partially tighten six 1/2" x 1" Screws (35) with four 1/2"
Split Washers (49) and two 1/2" Star Washers (83)
through the bracket near the right Upright (93) and into
the Base Frame (56) as shown; do not tighten the
Screws yet. Be careful not to pinch any wires.
Repeat this step on the left side of the incline trainer.
Start all twelve 1/2" x 1" Screws (35), and then
tighten them.
Remove the pieces of wood (A) from under the Base
Frame (56).
93
56
35
35
35
49
49
83
4. Set the console assembly face down on a soft surface to
avoid scratching the console.
Remove and discard the four indicated screws (B) from
the console assembly.
Remove the Console Back Cover (104).
Console
Assembly
B
B
4
5. With the help of a second person, hold the console
assembly near the Upright (93). Connect the Upright
Wire (116) to the console wire (C). See the inset draw-
ing. The connectors should slide together easily and
snap into place. If they do not, turn one connector and
try again. IF YOU DO NOT CONNECT THE CONNEC-
TORS PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE POWER. Next,
connect the Upright TV Cable (89) to the console TV
cable (D). Insert the wires downward into the Upright
(93).
C
D
Console
Assembly
93
116
89
5
B
116
104
A