10
ADDITIONAL ADJUSTMENTS
Tower Pulley Adjustment–
Tools required: 5/16" hex key, 9/16" open end
wrench
1. Lift the top weight off the
weight stack and insert the
weight pin into the second
weight and the sixth hole
from the top of the weight
rod.
2. Loosen the locknut attach-
ing the pulley to the brack-
et in the top of the tower.
3. Move the pulley to the
appropriate location in the
bracket:
• If more slack is needed in
the cable, move the pul-
ley down.
• If less slack is needed in the cable, move the
pulley up.
4. Make sure that the cable guard is properly ori-
ented (see CABLE GUARDS on page 11) and
retighten the locknut attaching the pulley to the
bracket.
5. Lift the top weight and remove the weight pin.
Lower the top weight onto the second weight.
6. Readjust as necessary.
CABLE ADJUSTMENTS
CAUTION:
After making any cable adjustment, use
the strength equipment to lift a few weights while
someone makes sure that the cable is not derailed
from a pulley or rubbing on a cable guard (see
CABLE GUARDS on page 11).
INITIAL ADJUSTMENT
Top Weight Pulley Adjustment—
Tools required: 9/16" open or box-end wrench,
5/16" hex key
Note: If this adjustment does not remove the
excess slack, refer to ADDITIONAL ADJUST-
MENTS, below.
1. Using a 5/16" hex key and a 9/16" open or box-
end wrench, loosen the nut holding the pulley in
the “U”-bracket.
2. To increase the tension, slide the pulley down in
the slot. To decrease the tension, slide the pulley
up.
3. Tighten the nut and check the tension as
described in CABLE TENSION CHECK. If nec-
essary, readjust the pulley.
Pulley
Slot
“U”-bracket
Locknut
7
ADJUSTING THE CAM
2
RESISTANCE
The CAM
2
resistance can be adjusted to either a 1:1
ratio or a 1:2 ratio to the weight stack. At a 1:1 ratio,
the resistance will be equal to the weight of the
weight stack. At a 1:2 ratio, the resistance will be
equal to one-half the weight of the weight stack.
To change the CAM
2
resistance to a 1:1 ratio, pull the
CAM
2
knob out and move the CAM
2
to the HEAVY
slot in the pivot plate. Make sure the knob fully
engages the slot.
To change the CAM
2
resistance to a 1:2 ratio, pull the
CAM
2
knob out and move the CAM
2
to the LIGHT slot
in the pivot plate. Make sure the knob fully engages
the slot.
CAM
2
Knob
HEAVY
Slot
LIGHT
Slot
WARNING:
Always make sure that
the CAM
2
knob is fully engaged into the slot in
the pivot plate before using the strength
equipment. Make sure the spring (not shown)
is in place and functioning properly.
