MODEL: P800AJS
HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672
12
MODEL: P800AJS
HTTP://WWW.FREEMANTOOLS.COM 1-888-669-5672
13
ISSUE
POSSIBLE CAUSE(S)
CORRECTIVE ACTIONS
Car will not jump
after following all
of the necessary
steps
Check error lights.
The battery may be damaged.
The vehicle’s battery may not be
the issue.
The car jumper is not powered
on.
The car jumper cables do not
have a good connection.
Vehicle was not in PARK.
Car jumper does not have
enough charge.
Battery terminals are dirty.
Refer to step 3 under the “JUMPING A CAR”
section of the manual.
Replace the car’s battery.
Refer to your vehicle owner’s manual or have the
car taken to a certified mechanic to determine the
issue.
The car jumper will power off if you do not try to
start the car within 30 seconds of powering on
the jumper. If it is off turn the jumper on.
Ensure the cable clamps have maximum
connection on both sides of each clamp.
Place the car in PARK, some vehicles cannot be
started when not in the PARK setting.
Charge your car jumper.
Clean battery terminals to provide a better
connection.
TROUBLESHOOTING
WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a qualified service person or an
authorized service center.
MAINTENANCE
CLEANING
Clean the entire tool with a cotton rag after each use.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and maybe damaged by
their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
Make sure to charge the car jumper after
it is used. Charge the product every 3-6
months in order to prolong the battery
life.
WARNING:
WARNING:
Do not let brake fluids, gasoline,
petroleum-based products, penetrating
oils, etc. come in contact with plastic
parts. Chemicals can damage, weaken
or destroy plastic which may result in
serious personal injury.
Power Button
USING THE LED LIGHT
1. Hold power button until the LED light powers on.
Press power button to cycle through the different
light modes (normal, strobe, SOS, and off).
