PBA100 Rev0305PreLim
19
PRELIMINAR
Y
DOCUMENT
FOR REFERENCE/REVIEW
ONL
Y
Program Code Descriptions
When a valid four digit program code has been entered, stored data or program
options will show in the displays. (Refer to Programming.)
The
MENU
and
SILENCE
buttons are used to change the data. The
SILENCE
button will select the digit that is to be changed. The
MENU
button will change the
digit or change the option choice.
Data Display Codes 1000
1110 - Fault Warnings
This code will display the last ten (10) fault warnings that have occurred. The
RPM display will show a fault code and the message display will alternate between
showing the date and time that the fault occurred. Refer to Table 2. Fault Warnings
1120 - Maximum Engine RPM
This code will display the maximum RPM that the engine has attained.
Parameter Settings Codes 2000
2110 - Clock
This code will allow the clock display to be changed.
2120 - Date
This code will allow the date display to be changed.
2130 - Clear Fault Warnings
This code will allow the stored fault warnings to be cleared from memory. It will
clear the history of all five (5) fault warnings. Select YES or no.
2140 - RPM Calibration
This code will allow the digits in the RPM display to be adjusted to match a
tachometer. This is for engines that do not receive RPM data over the datalink and
have the yellow RPM signal wire (pin 12 on the 12-pin connector) connected to an
RPM source.
2150 - Perform System Test
Exit Program Code Mode
Press the
SILENCE
button first then the
MENU
button and hold them both for 3
seconds to exit the program code mode and return to normal operation.
