36G-PLATE
FIGURE 2
FIGURE 2-A
Remove all grub-screws from threaded holes on
your G-Plates.
PRO TIP:
LEAVE THE GRUB-SCREWS IN YOUR STACKING PLATES TO
FURTHER HELP IDENTIFY WHICH HOLES TO HAVE THE GUIDE PINS
FOLLOW THROUGH. REMOVE THE GRUB-SCREWS FROM EACH PLATE
BEFORE STACKING ANOTHER.
Once your spigot is in place and on the Guide Pins,
begin to remove them from the stack.
This will give a clear visible path to the bottom
plate’s threaded holes.
FIGURE 1-A
FIGURE 3
PACKING FOAM
After Guide Pins are removed,
thread the supplied hardware to
the bottom plate.
FIGURE 4
“NAKED” THREADLESS HOLES
GRUB-SCREW (THREADED HOLES)
FIGURE 1
36G-PLATE
40G-PLATE
40G-PLATE
40G-PLATE
1. Once your 40G-Plate is unpacked, move into the desired location you will be mounting the umbrella. Once in place immediately
remove and discard ALL Grub-Screws from the G-Plate (
FIGURE 1
).
2. Locate your pair of Guide Pins and hand tighten into a pair of parallel threaded holes into the 40G-Plate you have set into place and is
designated as your bottom plate (
FIGURE 1-A
) .
3. Begin to unpack your 36G stacking plate. Using a half of the white packing foam, place on the edge of the bottom plate already in
place and set down your plate (
FIGURE 2A
). This will help prevent any pinching of your fingers or injury.
4.
TWO PERSON JOB
: Lift your 36G-Plate (
FIGURE 2
), and slowly stack the plate with the “naked” non-threaded holes over the Guide
Pins. If the plate does not pass through and set down, please check to be sure you have rotated the plate to line up the “naked” holes
with the Guide Pins.
5. Once all three plates are stacked, and over the Guide Pins, retrieve and remove the Spigot from the mast of your Aurora umbrella.
Place the Spigot over the Guide Pins (
FIGURE 3
) then remove the Guide Pins and you will have a clear visible path to the bottom
plate’s threaded holes.
6. With your Spigot in place on G-Plate stack lined up to the outer four bolts, use the supplied hardware that is packed with your
umbrella and bolt the Spigot onto the G-Plate stack threading down into the bottom plate (
FIGURE 4
). Once your Spigot is secure to
the G-Plate stack, begin to lift the Aurora onto the Spigot until you hear an audible “click” indicating your umbrella is secure.
40G+36G ROUND GALVANIZED PLATE STACK
Your Aurora Cantilever comes with the Spigot already inserted in the mast of your umbrella. Once you have properly stacked your G-Plate,
remove the Spigot from your umbrella and you can begin to mount your Spigot to the plate stack, and then the umbrella. (see
FIGURE 4
).
AURORA
SCAN THE QR-CODE FOR VIDEO TUTORIAL
GRUB-SCREWS ARE IN PLACE TO PROTECT THE THREADED HOLES ON BASES DURING SHIPPING AND STORAGE. THEY
MUST BE REMOVED AND DISCARDED BEFORE THE INSTALLATION OF ANY UMBRELLA.
6MM ALLEN WRENCH
(REMOVE GRUB-SCREWS)
8MM ALLEN WRENCH
(MOUNTING HARDWARE)
GUIDE PINS
36G-PLATE
23
24
INCLUDED G-PLATE DOUBLE STACK SPECIFIC MOUNTING HARDWARE
1.4” X .5” (8MM ALLEN KEY)
