8
13
Install the boiler
Important note:
Do not plug the boiler into the power supply
at this stage.
For ease of installation the boiler connections and the flexible
hoses are colour coded:
Green
- Filtered water
Red
- Boiling water
Black - Vent
1. Remove the protective caps from the three connections
on the top of the boiler.
2. Place the boiler (12) in position upright on a flat surface
inside the cabinet with the connections to the top.
3. Take the G¼” female nut (21.B) at the free end of the
filter outlet hose (green indicator). Carefully position the
flat silicon washer (15) inside the nut. Screw the nut onto
the G¼” male boiler inlet (green dot). Hand tighten using
the attached NutRunna
®
sufficient to make a watertight
seal. Do not overtighten.
4. Take the free end of the boiling water flexible hose
attached to the base of the tap (red indicator). Carefully
position the tapered silicon washer (14) on the G1/4”
male boiler outlet (red dot). Take the spare G1/4”
NutRunna
®
(10) and place over the nut. Screw the nut
onto to the G1/4” boiling water outlet of the boiler
(red dot). Hand tighten the nut firmly, sufficient to make a
watertight seal. Do not overtighten.
5. Take the push-fit elbow (13). Connect the elbow to the
grey push-fit stem on the end of the vent flexible hose
(18) (black indicator). Push the push-fit elbow firmly home
in place onto the metal spigot (black dot) protruding from
the top of the boiler.
6. Use the cable ties (9) to neatly secure the various flexible
hoses out of harm’s way.
Install the filter change indicator module
1. Install the 2x AA batteries (4) in the module (2). A “bleep”
will confirm that they are correctly installed.
2. Choose a convenient location for the module, on the side
of the cabinet or the boiler, making sure that the attached
power cable is within easy reach of the mating cable
attached to the base of the tap.
3. Secure the module in place using the self-adhesive Velcro
pad provided.
4. Plug the two cables together.
5. The LED light on the tap will glow RED followed by GREEN
and the emit an audible BEEP before turning off.
The LED indicator:
Red
- Indicates that the water filter cartridge needs
replacing.
Yellow
- Indicates that the two AA batteries in the module
need replacing.
Flat silicone
washer
Tapered silicone
washer
Female-female
push fit elbow
Flat silicone
washer
Tapered
silicone
washer
Female-female
push fit elbow
