10
Operating the Omni tap
The body of the tap is clearly marked to show the 4 functions.
Normal unfiltered mains hot and cold water.
The hot and cold water is controlled in the normal manner
by the lever opposite the boiling/cold filtered water lever.
Boiling Filtered water
Remove the red safety clip (3)
Depress the boiling water lever to release
the safety lock and rotate it against the
spring pressure.
Guide the boiling water lever back to the ‘’OFF” position.
Note: Do not just release the handle or it will pass through
the “off” position and turn on the cold filtered water.
The correct way to dispense the boiling water is to contain
the end of the spout inside the vessel you are filling; gradually
lowering the container as it fills.
Cold filtered water
The cold filtered water function is controlled
by turning the boiling filtered water lever in
the opposite direction, but without the need
to depress the lever to disconnect the safety
lock beforehand.
Mains Cold
Mains Hot
Filtered Boiling
Filtered Cold
Removable
Safety
Clip
Mains Cold
Mains Hot
Filtered
Cold
Filtered
Boiling
Removable
Safety
Clip
Care and maintenance
Cleaning the Omni tap
The Omni tap is manufactured in stainless steel and is
therefore extremely durable and stain resistant. All that is
required to keep it in good condition is a regular wipe over with
a damp cloth - Franke offer a micro-fibre cloth for this purpose
that can be purchased on line at www.frankefilterflow.co.uk—
and an occasional wash with a proprietary moisturising hand
cleaner or the application of a small amount of baby oil on a
soft cloth or tissue will also help to keep the finish bright and
free of smears.
Changing the batteries in the filter cartridge change module
If necessary separate the module from the Velcro pad and
slide off the battery cover at the side of the module. Remove
the battery carrier and replace the two old AA batteries with
two new ones. Press the reset button.
Removing the boiler
1. Disconnect the electricity supply to the boiler.
2. Operate the boiling water function and run the boiling
water until the water flowing from the spout runs cold.
3. Shut off the water supply to the boiler.
4. Operate the boiling water for a second time until the water
stops flowing to release the pressure in the boiler.
5. Disconnect the hoses from the boiler using a suitable
container to catch residual water.
6. Remove the boiler carefully, unscrew the brass drain nut
at the base and pour out the water it contains.
100°c
