Franke FWM 12005 EI, Инструкция пользователя, Страница: 5 / 48

ENGLISH
Installation
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner unscrew and remove the rear
right bolt. Lay the machine gently on its back,
making sure that the hoses are not squashed.
2. Remove the polystyrene base and take off the
bottom panel by unscrewing the central screw.
Carefully slide out the right polythene bag.
3. Repeat the operation for the left and central
polythene bags.
4. Re-fit the bottom panel using the 4 screws
supplied with the door hinges (in the plastic bag)
and the previously removed screw.
P 045 3
P 00 1 6
P 00 1 5
P 0457
P 0255
5. Fasten the base-covering grid (supplied with the
machine) to the lower panel, removing possible
fillets. Use the two supplied proper screws.
The grid consists of detachable 8 filets, to permit
the below alignment among the appliance and
the adjoining forniture.
6. Fit cover bottom as the picture shows (inserting
the hook in the basament).
7. Set the machine upright and remove the two
remaining bolts from the back.
8. Pull out the three plastic spacers from the holes
into which the bolts were fitted.
9. Plug the open holes with the plugs supplied with
the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
P1 05 1
P 0002 P11 2 8
P1 075 P 0454
5
132970760 GB.qxd 05/06/2007 11.16 Pagina 5