Franke FWM 12005 EI, Инструкция пользователя, Страница: 17 / 48

ENGLISH
12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the machine
is already heating, that the water level is above the
bottom edge of the door or that the drum is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by depressing the
ON/OFF button
. After about some minutes the
door can be opened (pay attention to the water level
and temperature!). To restart the programme
depress ON/OFF button again after closing the door.
13. At the end of the programme
The machine stops automatically. The light of the
START/PAUSE button goes out, the END pilot light
illuminates and the door can be opened.
If the RINSE HOLD or NIGHT CYCLE option has
been selected, the door will be locked, the RINSE
HOLD light remains lit to indicate that the water must
be drained before opening the door. A blinking zero
appears on the display.
To empty out the water you can, after turning the
programme selector dial to
Off position:
- select programme DRAIN, the water is emptied
out without spinning
- select programme SPIN. Select the spin speed by
means of the relevant button and then depress the
START/PAUSE button. The water is emptied out
and the laundry is spun at the selected spin
speed.
At the end of the cycle, and the END light illuminates
and the START/PAUSE goes off. The door can be
opened.
Turn the programme selector dial to Reset Off .
Switch the machine off by pressing the ON/OFF
button.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
17
8. Start the programme
To start the selected programme, press the
START/PAUSE button; the corresponding light stops
flashing.
The pilot light corresponding to the wash phase
which is running is on.
The machine starts operating.
9. Altering an option or a programme
which is running
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to
Off
and then to the new programme position. The
washing water in the tub will not emptied out .
Start the new programme by depressing the
START/PAUSE button.
10. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
11. Modifying or cancelling a programme
which is running
Turn the selector dial to
Off
to cancel a programme
which is running. Now you can select a new
programme. The water in the drum will not be
emptied out.
132970760 GB.qxd 05/06/2007 11.17 Pagina 17