9
INSTALLATION INSTRUCTIONS
The installation comes under the exclusive responsibility of service. The installer must respect the legislation and the standards enforce in his
home country.
•
The bench top or the support in which the cooktop is to be fitted, as well as the edges of the furniture, the laminates coatings and the glue
used to fix them, must be able to resist temperatures of up to 100°C.
•
Do not install the cooktop to the top of a non ventilated oven or dishwasher.
•
The underside of the cooktop requires a clearance of 20mm from the under side of the induction unit to ensure good air circulation of the
electronic device.
•
If a drawer is placed under the unit, do not put flammable objects (for examples sprays) or non heat resistant objects inside.
•
The over head clearance should be 750mm unless the over head surface is non combustible or the range hood is rated for lower clearance
taking into account the installation requirements of AS/NZ 5601
where applicable.
•
Where the appliance is supplied to be plugged into a GPO the plug must not be removed.
•
Where the appliance is supplied with two power leads the GPO’s must be rated to suit the plug or greater.
How to stick the gasket
The gasket supplied with the cooktop avoids all infiltration of liquids in the cabinet. Installation has to be done carefully, in conformity of the
following drawing.
Fitting - installation:
•
The cut out sizes are:
Stick the gasket (2) two millimeters from the
external edge of the glass, after removing
the protection sheet (3).
FIXG905B1 N/L, FIXG903B1 N/L, FIXG9041B2 N/L
A+5m
m
817
mm
378mm
850m
m
405mm
A
305mm
58mm
60mm
A+20m
m
960
mm
470mm
230
mm
55mm
125mm
1,015mm
A
505mm
960mm
520mm
480mm
920mm
50mm
60m
m
70mm
FIXG903
FIXG905
FIXG9041B2
Respective locations of gas inlet and power supply