1T 310'177 Operating Manual
Ecolino
Erstellt: 01.05.2002 Rev.: C SL: 20'987 BJC
page 11
2.1.1 Messages during use with chip cards
product distribution
If a chip card is inserted during product dispensing, this
locked selection
message appears. You must remove the chip card and you
cannot reinsert it until product dispensing is complete.
wrong ID- number
The installation number is not identical. This message appears
remove card
if a Download Card of another machine is inserted. This card
does not function on this coffee machine. Ascertain whether
you are using the Download Card assigned to the coffee
machine.
locked selection
This message only appears by versions "autosteam" if the
temp.probe-2 defect
temperature probe is defective
select product
The product output is still possible.
repl. watersoftener
select product
(See Section 3.5 Daily cleaning)
clean
The product output is still possible.
select product
There is a fault in the water flow.
error flowmeter
- Is coffee being dispensed normally at the coffee outlet?
YES: The Service Department must be contacted.
NO: Was an adjustment made with the Adjust Card?
YES: Insert Download Card and proceed according to
Section 4.2.1.2. If the message reappears, contact the Service
Department.
NO: Contact Service Department since there may be a
blockage in the infusion system.
locked selection
Please check the water container.
watercont./reset "+"
locked selection
The connection between CCI/CSI interface is broken. Contact
no communication
the Service Department. To enable you to continue dispensing
products, switch the accounting system off using the
Management Card, according to Section 6.1.5.2.
blocking button
A key is blocked. The jamming can be eliminated by pressing
locked selection
the blocked key again.
