An offset is available in order to offer the possibility to modify the init position if necessary. As a
standard this value is set to 0. This value must be entered in degrees.
When the turntable had finished the initialization, the reference starting point is 0,0°.
➔
Click on
Turntable/start init
to start the initialisation run of the turntable
The accuracy of our turntables is +/- 0,2°. Our controller FC 02 is a high resolution, and it can control the
turntables with a resolution of 0,1°.
Our turntable presents 30 levels of speed (more details are available in the FTT user manual).
With our software, you can set what you want into the right white cases:
•
Target: from –200° to 200° (depending on the settings for offset & limits)
•
Step: from 0 ° to 200°
•
Speed: from 1 (slow) to 30 (fast)
•
Please notice: The rotating knob represents the physical position of the turntable and is not
influenced by the settings of limits and offset!
The displayed values (deg) take into account the setting of offset!
•
If the software detects a motion initiated by an external software all buttons except the Stop
button are disabled. All buttons are enabled again 20 sec after the motion stops.
Target is the angle where you want to go. When you click on start the turntable will move to this place at
the speed choosen.
Step is a step of angle which will be reproduced each time you click on Step + or Step – at the speed
choosen.
Before the use of high speed, be sure that the equipment under test is fixed correctly
.
MA_FC02_(Rev2_1) - 9/06 / Version 1 / Rev:2.1
12 / 24
