FRANCO srl Manual of use and maintenance UCP-fly
16
4.3 Changing the float
Disconnect the water supply by releasing the spreader
pipe from the fast connection 3/8”.
Remove the two screws from the lid using a crosshead or “Phillips” screwdriver. Remove the cover pulling it,
grabbing the grip between the thumb and the forefinger.
After unscrewing the ½” connection with the 3/8” tube fast connection, unscrew the plastic ring nut indicated in
Fig. 4.3 and, consequently, remove the body of the float.
Place the new float and repeat the sequence in the reverse order, so that the water level inside the tank covers
the pump completely.
Fig. 4.1
Fig.4.3
4.4 Changing the pump
Remove the two cover screws using a cross or “Phillips” screwdriver. Remove the lid by pulling it, grabbing the
grip between thumb and forefinger. Unscrew the plastic arm of the float as shown in Fig. 4.1. Operate holding
the stop ring that blocks he pump with a no. 13 spanner and pull the pump gently up to complete removal.
Remove the nylon pawl from the pump supply and fit it onto the new pump. Repeat the sequence backward,
being careful to reposition the float so that the water level inside the tank covers the pump completely.
4.5 Replacing the nozzle
After removing the spinning disk (par. 4.5), remove the nozzle unscrewing n.2 - 2,9x9,5 screws.
Push the grey ring on the elbow connection (page 22 - item 22) and pull out the nozzle.
To place the new nozzle, repeat the same sequence in the reverse order.
Fast connection 3/8”
