FRANCO srl Manual of use and maintenance UCP-fly
3
1 - INTRODUCTION
1.1 General warnings
This device must be used only for the functions it was intended for: "Adiabatic Cooler
– Humidifier”. Any other
use has to be considered improper and dangerous. Franco s.r.l. cannot be held liable for any damages caused
by improper, incorrect or unreasonable use, or if the device is used in systems that do not comply with safety
regulations.
- Check the integrity of the device at the opening of the package, paying particular attention to the presence of
damages or deformations of the plastic parts that can lead to breakage and/or malfunction during use. In such
cases do not connect the machine to the main. Carry out these checks before each use.
- Before connecting the unit, make
sure that the data shown on the device’s plate matches that of your electricity
distribution network. The data label is located on the side of the device (par.1.9).
- Respect the safety standards set for the electrical equipment and in particular:
o
Follow the installation and operation instructions concerning the use of the equipment.
o
Do not place objects on the humidifier.
o
Ensure that children and/or unable subjects cannot use the device without proper supervision.
o
Do not touch the humidifier during operation or until the complete stop of the disk.
o
Never immerse the device into water or any other liquid. In case of the device becoming wet,
immediately turn off the electricity by lowering the switch on the electrical panel of your system and
disconnect the power before touching the device.
o
Do not insert objects inside the tank as the device may be damaged irreparably.
o
Do not use accessories, spare parts and/or components which are not provided or supplied by the
manufacturer.
o
Avoid touching the appliance with wet and/or humid hands.
o
Do not pull the power cord nor expose it to risk of severing.
o
Do not expose the unit to weather (rain, sun, etc...).
o
In case of failure or malfunction, switch off immediately and disconnect the power. Do not try to open or
tamper the device: contact the technical service provided by Franco s.r.l.
o
Do not try to fill and/or empty the tank during operation.
1.2 Instructions for proper disposal of the product
In compliance with the European Directive 2002/96/EC.
At the end of its useful life the product must not be disposed of as waste.
The device can be taken to special recycling centers provided by local authorities, or at retailers that provide this
service. Disposing the product in separate parts avoids possible negative consequence to the environment and
to human health, which would both be the result of an inappropriate disposal, and allows the retrieval of
materials which results in significant savings in energy and resources. As a reminder of the obligation to dispose
electrical equipment separately, the product will be marked with the crossed-out wheeled bin.
Fig. 1.1