Step 6:
Before stacking your boards, lay them out around your 1
st
level frame.
NOTE
: Stacking stakes will be used for the second level of the design.
Step 7.
Start your 2
nd
level by connecting the 6/7/9 joint first.
Have the bracket for the gate board (6) on the bottom of the
joint as shown in the picture to the left. Then continue from
this point stacking the remaining 2
nd
level boards.
ASSEMBLY INSTRUCTIONS
–
Animal Barrier Gate
NOTE
: Part 12 will not be used
if installing the gate to Board
connector
Step 1
: Install an adapter cap (
Part
21) on top of each of the 9 outer joints on your second
level.
1
1
2
2
2
3
3
3
3
4
4
5
6
7
8
8
8
8
9
9
6
9
9
9
3
150
9
*Optional
9
7
Gate spacer sleeve. Only used
if stacking a second level of
animal barrier.
2
THIRD
: Add two curved tubes (
18
) to create the top and the bottom edges of the
left gate. When inserting the round and square tube into the corner joint, make
sure to insert each tube shape into the correct side. One side is for the square
tube and one side is for the round tube.
