FRAM FMG-2500X, Руководство пользователя

Страница: 15 / 37

14
ASSEMBLING
•
Press the fasten button, hold the
head and insert it into the
inlet(when inserting please pay
attention the head must be adjust
the appropriate direction until
close to and inlet, see fig.1). Then
push the locking handle until the
vertical position and tube (fig.2).
•
Place the snake into the head, long
end first, and turn to feed the
screw slightly until it is set into the
motor housing (fig.3).
•
Place the cutting blade onto the
snake shaft with the blade facing
the front as illustrated (fig.4). If it is
not fitted properly, meat will not
be grinded.
•
Place the desired cutting plate next
to the cutting blade, fitting
protrusions in the slot (fig.5).
•
Support or press the center of the
cutting plate with one finger then
screw the fixing ring tight with another hand (fig.6). Do not over tighten.
•
Place the hopper plate on the head and fix it into position.
•
Locate the unit on a firm place.
•
The air passage at the bottom and the side of the motor housing should be kept free and not blocked.
MINCER
•
Insert the worm shaft into the cutter housing, the plastic end first.
•
Place the cutter unit onto the worm shaft (the cutting edges should be at the front). Place the medium
grinding disc or coarse grinding disc (depending on the consistency you prefer) onto the worm shaft.
(Make sure the notch of the grinding disc fit onto the projections of the mincer head.) Turn the screw
ring in the direction of the arrow on the cutter housing until it is properly fastened.
•
Attach the cutter housing to the motor unit.
•
Place the tray on the upright part of the cutter housing.
•
Now the appliance is ready for mincing.
5. USING THE APPLIANCE