COOLING IN INDOOR OPERATION
The unit stands in the room to be cooled.
Connect the air hose and the air outlet grid to the unit as shown in the illustration.
The warm extract air must be emitted from the room via the air hose. This can be executed e.g .via atilted
window, a door or wall aperture. Make sure that now arm outside air can enter the room. For effective
cooling, we recommend our selection of various accessories which reduce or prevent entry of warm air into
the room.
Place the function to “COOLING”. Set the target temperature using the temperature control. The settable
Temperature range is between 17 and 30 degrees target temperature. The unit must only be used in an Ambient
temperature of maximum 45°C.
Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control lamp has
flashed for three minutes. Cooling effect may require a further 10 minutes. Further information is available under
the item, “Troubleshooting”.
hot air
cold air
cold air
hot air
CAUTION!: INSTALLATION BRACKETS EXTEND VERTICALLY
UPWARDS AS SHOWN BELOW
THE BRACKETS ARE REMOVED FROM THE UNIT BY PULLING VERTICALLY TO THE TOP AND INSTALLED BY
SLIDING VERTICALLY DOWN. DIFFERNT WAY OF REMOVING/INSERTION WILL BREAK FASTENERS IN THE
UNIT.
PL
22
www.uni-lux.eu
