5. LED-DISPLAY
The display shows the setting temperature in operation. By pressing the
[TEMP+]
or.
[TEMP-]
switch, the required target temperature is
briefly
displayed. On pressing
the
[TIMER]
switch, the number of hours is
briefly
shown until activation or deactivation. The display automatically shows the setting temperature. In the
dehumidific
a-
tion function, “DH” is shown in the display. Error messages are also shown in the display.
6. [SPEED]
Press this switch to set the ventilation speed to “LOW”, “MID” (middle), “HI” (high) or “AUTO” (automatic). If “AUTO” is selected, the ventilator operates at temperature
diff
erences larger than 9 degrees at top speed. If the temperature reduces to a
diff
erence smaller than 4 degrees, the ventilator switches to middle blower position. If the
temperature reduces further until the target temperature, the ventilator switches to the lowest blower position.
[TIMER]
Programmable time switch with start and residual time
Starting time: This function is used to switch on the unit automatically when the time entered has expired. Proceed as follows:
I) Press
[TIMER]
switch in Stand-by (this unit is connected but not in operation), to enter the required number of hours after which the unit is to start.
II) Select the required function (cooling, heating
, dehumidific
ation) and set the required temperature.
III) When the set number of hours has expired, the unit starts automatically.
If you press the
[POWER]
switch before the time has expired, the time programming is deleted. The unit switches on and can be operated in the required operating mode.
Residual time: This function is used to automatically deactivate the unit when the time entered has expired. Proceed as follows:
I) Press the
[TIMER]
switch during operation and enter the required number of hours after which the unit is to swit
ch off
.
II) After the
flashing
of the number of hours on the LED has stopped, you can select the required function (cooling, heating,
dehumidific
ation) and the required tempe-
rature.
III) When the set number of hours has expired, the unit switches on automatically.
If you press the
[POWER]
switch before the time has expired, the Timer programming is deleted and the unit swit
ches off
.
8. [SLEEP]
Using this key you can set the sleep function of the unit. The microprocessor integrated in the unit will raise the pre-set temperature by 2°C per hour up to a maximum of
4°C after 2 hours and maintain this temperature until the set time has expired. To change the temperature, press the switch
[TEMP+]
or
[TEMP-]
. With each press on the
switch, the temperature increases or decreases by 1°C.
REMOTE CONTROL
1. Power – switch on/swit
ch off
2. FUN – select functions
3. Timer – time programming
4. Auto – automatic ventilation mode
5. Hi – high ventilation speed
6. MID – middle ventilation speed
7. LOW – low ventilation speed
8. SLEEP – sleep function (night mode)
9. TEMP – temperature control
9
8
4
9
7
6
1
5
3
2
FRAL SUPER COOL
FSC09.1 R290A
FRAL POLSKA Sp. z o.o. - www.fral.pl
18
FSC09.1 R290A PL/EN/DE 14/04/2020 WER.1
