FSW 63
FSW63-14 Multilanguage 01/03/2016
47
CONTROL PANEL
The Electronic card with microprocessor, control many functions:
Heat led (Only for models with heater function);
when the heating function is
activated, the LED pulses every 10 seconds, when the heating element is powered
the LED remains lit.
Power LED;
it’s on when the machine is in the ON state.
Alarm LED;
it’s on when an alarm comes on. It turns off if the alarm is reset.
Run LED;
the LED is on when the compressor is running, blinks when the
dehumidifier is waiting to restart or is in defrost. It’s switched off when, in the ON
state, the set of desired humidity has been reached.
Full LED;
this LED is lit when the condensate tank is full. When PUMP function is
activated it blinks every 10 seconds.
Remote Function LED;
the machine has the possibility of using a remote humidistat or
switch. For this purpose, it needs to change the set in the PCB: with plug inserted in
the socket, put the machine in OFF position, then press all together these 3 buttons
for 4 seconds: HOUR COUNTER, SET UP and SET LOW , the machine changes and led
REMOTE turn on. Pay attention that if the humidity is set in cont position, machine
works not considering the remote control.
Remote LED; lights up when the machine is controlled remotely.
ON/OFF
(Only for models with heater function);
When the machine is ON, you can
activate the heating function by pressing and holding the button HEAT for 4 seconds.
Same procedure to disable it.
ON/OFF
function;
plugged into the outlet (with ground wire!), the display turns on and
shows the relative humidity in the room.
The machine is in the OFF state when the Power LED is off. It’s in the ON state when the
Power LED is on.
When OFF, to switch on the dehumidifier, simply press the POWER key and depending
on the relative humidity set the machine starts working.
When the machine reaches the level of required moisture goes into stand-by mode:
automatically stops but remains in the ON state (POWER LED on).
If the humidity goes above the set point the dehumidifier starts again.
When ON to put the dehumidifier in OFF just press the POWER button (the display
continues to indicate the humidity in the room).
Note: putting the machine OFF and immediately ON, the compressor does not start
immediately and the Run led starts to flash. After a time of 210 seconds the machine
restarts.