84
Doc Q7.0
Mixer [MIX]
5.18
The
Mixer
block contains a simple, linear mixer able to combine up to four stereo signals into either a stereo or
mono mix. Each pair of gain and balance controls corresponds to a
row
of the grid. For a more thorough
description of how Axe-Fx II mixers work, see section
, Mixology, on p.
The Mixer block supports X/Y Switching on the XL/XL+ only. See p.
for more information.
Page 1 Parameters
GAIN 1
– Sets the level for the incoming signal from a block in
row 1
of the column left of the mixer.
BAL 1
– Sets the balance between left and right signals of the block in
row 1
of the column left of the mixer.
GAIN/BAL 2, 3, 4
– These pairs of controls respectively set the level and balance of incoming signals from
the blocks in rows 2, 3, and 4 of the column left of the mixer.
Page 2 Parameters
LEVEL
– Sets the level of the output mix.
OUTPUT MODE
– Specifies whether the outgoing mix should be stereo or summed to dual mono.
Each Axe-Fx II preset can use two
Mixer
blocks. Note that on the Mark II, the mixer cannot be BYPASSED.
