12
U32-3 FPI Direct Vent Gas Insert
BAY LOUVERS
1) Install top louver by sliding the two bracket
clips into the brackets located on top of the
bay door. See below. The fitted louver
leaves a small gap between faceplate bot-
tom and louver top.
Note: If any maintenance etc. must be
done in the firebox, first remove
the Bay louvers and door.
OPTIONAL BAY TRIM
Attach 4 supplied magnets each to the back of
the top and bottom trim pieces, and attach trim
to the top and bottom of Bay door.
2) Install bottom louver by sliding the two
bracket clips into the brackets located un-
derneath the bay door. Secure with 1 screw
into each Bottom Louver Mounting Bracket
as per diagram below. Use the bottom hole
in the bracket.
3) Slide the SIT valve extension knobs onto the
valve knobs. Match the correct ext. knob
with the valve knob.
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the
flush front. The standard flush door and glass
must remain on the unit. Hook the top of the bay
door over the flush door flange and swing the
bottom against the bottom flange of the flush
door. Press down on the Bay Bottom bracket
and push in until it clips behind the bottom of the
flush front.
Slide the valve extension knobs onto the valve
SIT Extension knobs for Bay Front only.
knobs. Match each extension knob with the
corresponding valve knob. Extension knobs
are for Bay Front installations only.
Removing Bay Door
To remove only the Bay Door - use a screw-
driver to unclip the Bay Bottom bracket from the
flush door and then swing up and unhook from
the top flush door flange.
To remove the Bay Door & the Flush Front
together, pull the hook from the slot in the
bottom door bracket under the unit (see Stand-
ard Flush Door instructions above). Then pull
the Bay Door and Flush door out and lift off of
the flange at the top of the unit.
INSTALLATION
2) Install the Spring Hinges on the left and right
side of the bottom of the Firebox using 2
screws per hinge.
3) Place the Bottom Louver near the hinge. Flip
hinge over the Bottom Louver and secure
using 3 screws.
Bottom Louver
Hinge
Location
