11
U32-3 FPI Direct Vent Gas Insert
To remove the flush door, reverse the above
steps.
NOTE: The chain must rest on TOP of the gas
inlet pipe never under it.
Diagram 3
Diagram 2
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for
2nd spring.
See diagram 3.
Diagram 1b
OPTIONAL
FLUSH TRIM
Attach 2 round magnets to the back of the top
trim piece and the other 2 to the bottom trim
piece, then attach trim to the top and bottom of
Flush door.
INSTALLATION
FLUSH LOUVERS
Diagram 1a
STANDARD
FLUSH DOOR
The standard flush door comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1. Be careful
that the glass gasket does not roll up; there must
be a gap between the gasket and the door lip to
ensure that the door sits securely on the unit.
Diagram 2.
Diagram 4
Diagram 5
11) Push the Regency logo plate into the two
holes in the bottom left corner of the face-
plate.
OPTIONAL DOUBLE
DOOR FIRE SCREEN
Clip locations
Clip installed
on right side.
3) Open the screen door(s) and secure the
screen door to the flush door front with 2
clips on the bottom left and right side.
1) Pull out the top
louver.
2) Center the
screen door
and hook over
the flush
door.
1) The top louver is held in place by friction fit,
if the louver needs to be adjusted; bend the
bracket out as shown in the diagram.
