Foy BP305, Руководство пользователя и гарантия

Страница: 12 / 18

12
· Disconnect the mains plug before all work on
the appliance .
· Do not install and switch on the appliance
if there are people or animals in the medium
being pumped, or they are in contact with it.
· If repairs are carried out incorrectly, there is a
danger of liquid penetrating into the electrical
components of the appliance.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. TERMINAL COVER.
2. IN
3. OUT
4. PRIME VALVE
5. FAN COVER
6. FIXING HOLES
7. IMPELLER CASING
OPERATION INSTRUCTIONS
This pump is designed to suck water at a height
of up to 8 meters at sea level, this condition de-
creases as the height of the city or workplace
increases.
- For best results, install your water pump as
close as possible to the water mirror, the water
mirror should be at least 20 inches above the
foot valve. Calculate correctly the demand of
your system and the correct diameter of the
pipes.
- If your motor pump is going to be set at a
fixed place, attach it firmly to the floor (use
clamps, expansive raw plugs, etc.) Otherwise,
make always sure that it will not be moving for
the vibration.
The pump should be installed in a dry, properly
ventilated location at an ambient temperature
not to exceed 40 ° C (104 ° F)
NEVER ALLOW THAT YOUR MOTOR GETS
WET, USE PROTECTION COVER IF OUTDOORS.
AVOID COVERING THE MOTOR OF YOUR
MOTOR PUMP WITH PLASTIC THAT PREVENT
THE CIRCULATION OF AIR THROUGH IT SO
THAT IT COOLS DOWN. PLACE YOUR MOTOR
PUMP AT A VENTILATED PLACE.
PUMPING CONNECTIONS
- It is very convenient to use new pipes, prefer-
ably galvanized, along with some product to
seal connections (SURTEK
® threads sealer tape,
Cement, Pola, etc.). Use the fewer bends as
possible.
- Follow carefully the manufacturer’s instruc-
tions when installing plastic connections and
pipes.
ALWAYS USE PIPING WITH A DIAMETER
EQUAL OR WIDER THAN THE SUCTION HOLE
OF THE PUMP, NEVER SMALLER.
- Upon connecting the first pipe or nipple be
careful not to put it in too deep since it could
1
2
3
5
4
6 7
Minimum
water level:
20”
Foot valve
Water deposit
Sand
screen
Union nut
Valve
Swing flap check
(non-return)
Suction pipe
holder
Concrete
base
RIGHT INSTALLATION
WRONG INSTALLATION